Siemens SINUMERIK 802D sl Spezifikationen PDF herunterladen (Seite 299)

Cycle alarms

06/2007 Overview of alarms

2-299

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61261 Channel %1 block %2: center offset too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The center offset on center drilling is larger than permissible.

Alarm triggered by following cycles: F_DRILL, F_DRILLD.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter smaller center offset (see display machine data 9862).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61262 Channel %1 block %2: lead not possible with selected tool

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The lead of the tap does not match the programmed lead.

Alarm triggered by following cycles: F_DR_TAP, F_DRM_TA, F_TAP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use a tap with the programmed lead.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61263 Channel %1 Block %2: Chained ShopMill program blocks not permissible

in subprogram on pos. pattern

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If a subroutine is called from a position pattern, the subroutine itself must not include a position pattern.

The alarm is triggered by the following cycle: E_MANAGE

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Reprogram machining.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61264 Channel %1 Block %2: Chained ShopTurn program blocks not

permissible in subprogram on pos. pattern

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If a subroutine is called from a position pattern, the subroutine itself must not include a position pattern.

Alarm triggered by following cycle: F_MANAGE.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Reprogram machining.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 294 295 296 297 298 299 300 301 302 303 304 ... 391 392

Siemens SINUMERIK 802D sl Spezifikationen Seite 299

Kommentare zu diesen Handbüchern

Siemens SINUMERIK 802D sl Spezifikationen Seite 299

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl