Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 105)

NCK alarms

06/2009 Overview of alarms

2-105

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

10: The DRF movement for this axis cannot be executed as the axis is active as reciprocating axis

with handwheel override with this handwheel

Reaction: Alarm display.

Remedy: Use the handwheel for one purpose at a time only.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

14400 [Channel %1: ] Block %2 tool radius compensation active at

transformation switchover

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A change of transformation is not allowed when tool radius compensation is active.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Perform tool radius compensation in the NC part program with G40 (in a block with G00 or G01) before

performing a transformation change.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14401 [Channel %1: ] Block %2 transformation not available

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The required transformation is not available.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department.

Modify part program; program defined transformations only.

Check MD 24... $MC_TRAFO_TYPE_... (assigns the transformation to part program instruction).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14403 [Channel %1: ] Block %2 preprocessing and main run might not be

synchronized

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Positioning axis runs cannot be accurately calculated beforehand. Consequently, the position in the

MCS is not known exactly. It might therefore be possible that a change in the multiple significance of

the transformation has been performed in the main run although no provision was made for this in the

preprocessing run.

Reaction: Alarm display.

Remedy: Modify part program. Synchronize preprocessing run and main run.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

14404 [Channel %1: ] Block %2 illegal parameterization of transformation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Error has occurred when selecting transformation.

Possible causes of error:

- An axis traversed by the transformation has not been enabled:

- is being used by another channel (-> enable)

- is in spindle mode (-> enable with SPOS)

- is in POSA mode (-> enable with WAITP)

- is concurrent Pos axis (-> enable with WAITP)

- Parameterization via machine data has an error

- Axis or geometry axis assignment to the transformation has an error,

- Machine data has an error (-> modify machine data, restart)

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 339 340

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 105

Kommentare zu diesen Handbüchern

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 105

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl