Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 93)

NCK alarms

06/2009 Overview of alarms

2-93

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Alarm display.

Remedy: - Raise the execution right to match the protection level of part program %3

- Assign a lower protection level to part program %3 or release (key switch protection level 0)

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14016 [Channel %1: ] Block %2 error when calling the subroutine via M/T

function

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The following conflict was detected in a subprogram call per M or T function:

In the block referenced by parameter %2:

- An M or T function replacement has already been activated

- A modal subprogram call is active

- A subprogram return jump is programmed

- An end of program is programmed

- An M98 subprogram call is active (only in external language mode)

- T function replacement by D function programming in the same part program line is not possible with

active TLC (G43/G44) in ISO2 system.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: An M or T function replacement is only possible if a subprogram call or return jump has not already

been performed as a result of other program constructs. The part program must be corrected accord-

ingly.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14017 [Channel %1: ] Block %2 syntax error when calling the subroutine via M

function

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: When calling M code subroutine with parameter transfer, an illegal syntax was detected:

- Address extension not programmed as a constant.

- M function value not programmed as a constant.

Note:

If a parameter transfer has been programmed via MD10718 $MN_M_NO_FCT_CYCLE_PAR for an

M function replacement, the following restriction applies to this M function: both the address extension

and the M function value must be programmed for replacement as constants.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Change the programming of the M function.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14018 [Channel %1: ] Block %2 parts program command %3 not executable

(protection level setpoint value / actual value: %4)

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Programmed command

%4 = Protection level of the command / current protection level

Definitions: To parts program command %3, a protection level has been assigned that is logically higher (smaller

in value) than the current access right, or the command does not exist in the current control configu-

ration.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify parts program. Please see the Siemens Progamming Guide or OEM documentation for the

language commands permissible for the relevant system configuration.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 93

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl