Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 240)

Overview of alarms 06/2009

Cycle alarms

2-240

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Definitions: The alarm is triggerd by the following cycles: CYCLE961.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Define P1 and P2 or P3 and P4 in a way that the intersection of the straights determined by these

points is outside the sections formed by P1 and P2 or P3 and P4.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61370 [Channel %1: ] Block %2: _PROTVAL[0] -_PROTVAL[5] do not have any

entries

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggerd by the following cycles: CYCLE105.

Remedy: Enter values in _PROTVAL[0...5].

61371 [Channel %1: ] Block %2: Product of column width and number of

columns exceeds 200 characters per line

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggerd by the following cycles: CYCLE105.

Remedy: Reduce the column width (_PROTFORM[4]) or number of columns (_PROTVAL[2...5]).

61372 [Channel %1: ] Block %2: selected meas.variant requires SPOS-capable

spindle

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: Change measuring variant or check machine equipment.

61373 [Channel %1: ] Block %2: Mono-directional probe requires SPOS-capable

spindle

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: Check machine equipment.

61401 [Channel %1: ] Block %2: Probe not switching, traversing path limitation

through software limit position

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggerd by the following cycles: CYCLE961, CYCLE971, CYCLE976, CYCLE977,

CYCLE978, CYCLE998

The position defined by a setpoint value cannot be reached, as the software limit position has been

exceeded.

Remedy: Check specified setpoint value.

61402 [Channel %1: ] Block %2: Probe collision, traversing path limitation

through software limit position

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggerd by the following cycles: CYCLE977

For the measuring variant Measure web/shaft, the position path in the plane was limited by the soft-

ware limit position. The probe switched in the following infeed along the infeed axis.

Remedy: Check programmed position regarding software end position.

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 240

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl