Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 207)

Cycle alarms

06/2009 Overview of alarms

2-207

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61150 [Channel %1: ] Block %2: Tool cannot be aligned --> error code: %4

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE800.

Remedy: Error code:

A -> only new swivel plane permitted, see parameter _ST

61151 [Channel %1: ] Block %2: Orientation of tool not possible --> error code:

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE800.

Remedy: Error code:

A -> only additive swivel plane permitted, see parameter _ST

61152 [Channel %1: ] Block %2: B axis kinematics (turning technology) either

not or incorrectly set up in Start-up of swivel cycle --> error code: %4

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE800.

Remedy: Error code:

A123 -> B axis is not an automatic rotary axis under ShopTurn (123 corresponds to parameter

_TCBA)

B123 -> B axis is not activated in start-up swiveling (kinematics)

(123 corresponds to $TC_CARR37[n], n ... number of the swivel data record)

61153 [Channel %1: ] Block %2: No 'Rotary axes direct' swivel mode possible -

-> error code: %4

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE800.

Remedy: Error code:

A -> No tool or cutting edge (D1..) active

61154 [Channel %1: ] Block %2: Final depth wrongly programmed

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE899

Remedy: Input of end depth possible only absolutely or incrementally

61155 [Channel %1: ] Block %2: Unit for plane infeed wrongly programmed

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE899

Remedy: Unit for plane infeed possible only in mm or % of tool diameter

61156 [Channel %1: ] Block %2: Depth calculation wrongly programmed

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE899

Remedy: Depth calculation possible only with or without SDIS

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 207

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl