Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 135)

NCK alarms

06/2009 Overview of alarms

2-135

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

16914 [Mode group %1: ] [Channel %2: ] Mode change: action %3<ALNX> not

allowed

Parameters: %1 = Channel number

%2 = Mode group number

%3 = Action number/action name

Definitions: Incorrect mode change, e.g.: Auto -> MDIREF.

Reaction: Alarm display.

Remedy: Check operation or selected mode.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

16915 [Channel %1: ] Action %2<ALNX> not allowed in the current block

Parameters: %1 = Channel number

%2 = Action number/action name

Definitions: If traversing blocks are interrupted by asynchronous subroutines, then it must be possible for the inter-

rupted program to continue (reorganization of block processing) after termination of the asynchronous

subroutine.

The 2nd parameter describes which action wanted to interrupt block processing.

Reaction: Alarm display.

Remedy: Let the program continue to a reorganized NC block or modify part program.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

16916 [Channel %1: ] Repositioning: action %2<ALNX> not allowed in the

current state

Parameters: %1 = Channel number

%2 = Action number/action name

Definitions: Repositioning of block processing is presently not possible. A mode change cannot take place.

The 2nd parameter describes which action should be used to perform repositioning.

Reaction: Alarm display.

Remedy: Let the program continue to a repositioned NC block or modify part program.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

16919 [Channel %1: ] Action %2<ALNX> is not allowed due to a pending alarm

Parameters: %1 = Channel number

%2 = Action number/action name

Definitions: This action cannot be performed due to an alarm, or the channel is in the fault condition.

Reaction: Alarm display.

Remedy: Press the RESET key.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

16920 [Channel %1: ] Action %2<ALNX> is already active

Parameters: %1 = Channel number

%2 = Action number/action name

Definitions: An identical action is still being processed.

Reaction: Alarm display.

Remedy: Wait until the previous procedure has been terminated and then repeat the operation.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

16922 [Channel %1: ] Subprograms: action %2<ALNX> maximum nesting depth

exceeded

Parameters: %1 = Channel number

%2 = Action number/action name

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 135

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl