Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 224)

Overview of alarms 06/2009

Cycle alarms

2-224

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61258 [Channel %1: ] Block %2: set parameters for counterspindle chuck in the

spindle image

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The parameters for the counterspindle chuck have not been set in the spindle view.

Alarm triggered by following cycle: F_SUB_SP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Specify parameters "ZL1", "ZL2" and "ZL3" in mask "Tools work offset" > "Spindles".

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61259 [Channel %1: ] Block %2: program contains new machining steps from

ShopMill %4

Parameters: %1 = Channel number

%2 = Block number, label

%4 = ShopMill version

Definitions: The program has been created with a ShopMill version that is higher than the existing one.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Delete the machining step and reprogram machining if required.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61260 [Channel %1: ] Block %2: program contains new machining steps from

ShopTurn %4

Parameters: %1 = Channel number

%2 = Block number, label

%4 = ShopTurn version

Definitions: The program has been created with a ShopMill version that is higher than the existing one.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Delete the machining step and reprogram machining if required.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61261 [Channel %1: ] Block %2: center offset too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The center offset on center drilling is larger than permissible.

Alarm triggered by following cycles: F_DRILL, F_DRILLD.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter smaller center offset (see display machine data 9862).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 224

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl