Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 130)

Overview of alarms 06/2009

NCK alarms

2-130

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

16763 [Channel %1: ] Block %2 axis %3 programmed speed is illegal (zero or

negative)

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: A spindle speed (S value) was programmed with the value zero or with a negative value.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: The programmed spindle speed (S value) must be positive. Depending on the application case, the

value zero can be accepted (e.g. G25 S0).

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16770 [Channel %1: ] Block %2 axis %3 no measuring system available

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: One of the following spindle functions has been programmed, the position control requires:

SPCON,

SPOS, SPOSA,

COUPON,

G331/G332.

The position control requires at least one measuring system.

No measuring system has been configured in MD30200 $MA_NUM_ENCS of the programmed spin-

dle.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department. Retrofit a measuring system.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

16771 [Channel %1: ] Block %3 following axis %2 overlaid movement not

enabled

Parameters: %1 = Channel number

%2 = Axis name, spindle number

%3 = Block number, label

Definitions: No gear synchronization and no overlay movement can be executed because this is not enabled at

the VDI interface.

Reaction: Alarm display.

Remedy: Set the NC/PLC interface signal <Freigabe_Folgeachsueberlagerung/> (enable following axis over-

lay).

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

16772 [Channel %1: ] Block %2 axis %3 is the slave axis, the coupling is being

opened

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis, spindle

Definitions: The axis is active as a slave axis in a coupling. In the REF operation mode, the coupling is opened.

The alarm can be suppressed by means of MD11410 $MN_SUPPRESS_ALARM_MASK Bit29 = 1.

Reaction: Alarm display.

Remedy: The coupling will be closed again after having exited the REF operation mode.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 130

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl