Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 195)

Cycle alarms

06/2009 Overview of alarms

2-195

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Alarm display.

Remedy: Program tool (T).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61010 [Channel %1: ] Block %2: Finishing allowance too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The finishing allowance for the base is greater than the total depth. Alarm triggered by following cycle:

CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Reduce finishing allowance.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61011 [Channel %1: ] Block %2: Scaling not permissible

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A scale factor is active which is illegal for this cycle. Alarm triggered by following cycles: CYCLE71,

CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify scale factor.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61012 [Channel %1: ] Block %2: Different scaling in planes

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE76, CYCLE77.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61013 [Channel %1: ] Block %2: Basic settings were changed, program cannot

be executed

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The basic settings are not compatible with the generated program. Alarm triggered by following

cycles: E_CP_CE, E_CP_CO, E_CP_DR, F_CP_CE, F_CP_CO, F_CP_DR.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check and, if necessary, change the basic settings.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 195

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl