Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 106)

Overview of alarms 06/2009

NCK alarms

2-106

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Please note: Any axes not enabled might be signaled via alarm 14092 or alarm 1011 instead of alarm

14404.

Transformation-dependent error causes can be in: TRAORI: -

TRANSMIT:

- The current machine axis position is unsuitable for selection (e.g. selection in the pole) (-> change

position slightly).

- Parameterization via machine data has an error.

- Special requirement with respect to the machine axis has not been fulfilled (e.g. rotary axis is not a

modulo axis) (-> modify machine data, restart).

TRACYL:

The programmed parameter is not allowed when transformation is selected.

TRAANG:

- The programmed parameter is not allowed when transformation is selected.

- Parameterization via machine data has an error.

- Parameter is faulty (e.g. TRAANG: unfavorable angle value (-> modify machine data, restart)

Persistent transformation:

- Machine data for persistent transformation are wrong (-> consider dependencies, change machine

data, restart)

Only with active "OEM transformation" compile cycle:

The axes included in the transformation must be referenced.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department. Modify part program or machine data.

Only with active "OEM transformation" compile cycle:

Reference the axes included in the transformation before selecting transformation.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14411 [Channel %1: ] Block %2 tool radius compensation active at geometry

axis changeover

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: It is not permissible to change the assignment of geometry axes to channel axes when tool radius

compensation is active.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14412 [Channel %1: ] Block %2 transformation active at geometry axis

changeover

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: It is not permissible to change the assignment of geometry axes to channel axes when transformation

is active.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14415 [Channel %1: ] Block %2 tangent control: changeover geometry/channel

axis not allowed

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 106

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl