Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 312)

100

101

List of action numbers 06/2009

3-312

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

No. 116, TOOLCHANGECMDON

No. 117, TOOLCHANGECMDOFF

No. 118, SIVLIMCHANGE

No. 119, STOPRUN

No. 120, SINGLEAX_LIFTFAST_OFF_MASTER

No. 121, SINGLEAX_STOP_LIFTOFF_MASTER

Explanation Activate tool-management commands (Ch. VDI signal).

Cause The NCK channel is in a state other than "ready"

Remedy Abort the program or process with the Reset key or wait for end of program.

Explanation Deactivate tool-management commands (Ch. VDI signal).

Cause The NCK channel is in a state other than "ready"

Remedy Abort the program or process with the Reset key or wait for end of program.

Explanation Selection of desired safety limitations (SGE) (always allowed).

Cause -

Remedy -

Explanation Stop run, i.e., the NCK has automatically stopped at an OPI-defined block

Cause 1. Controller is not in automatic mode.

Remedy -

Explanation Rapid lift with a single axis

Cause The axis is not controlled by the PLC.

Remedy -

Explanation Rapid lift with a single axis has been stopped

Cause The axis is not controlled by the PLC and the single axis is not executing a rapid lift

Remedy -

1 2 ... 307 308 309 310 311 312 313 314 315 316 317 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 312

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl