Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 15)

NCK alarms

06/2009 Overview of alarms

2-15

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Please inform the authorized personnel/service department. The entries for the indices for the

machine axes used in the channels must be contiguous in table MD20070

$MC_AXCONF_MACHAX_USED. Channel axis gaps must be enabled via

MD11640$MN_ENABLE_CHAN_AX_GAP.

Program Con-

tinuation:

Switch control OFF - ON.

4002 [Channel %1: ] Machine data %2[%3] assigns an axis not defined in

channel

Parameters: %1 = Channel number

%2 = String: MD identifier

%3 = Index: MD array index

Definitions: Only axes that have been activated in the channel by means of MD20070

$MC_AXCONF_MACHAX_USED [kx]=m may be declared as geometry axes or transformation axes

by means of the MD20050 $MC_AXCONF_GEOAX_ASSIGN_TAB [gx]=k.

gx: Geometry axis index,

kx: Channel axis index,

k: Channel axis no.,

m: Machine axis no

Reaction: NC not ready.

Mode group not ready, also effective for single axes

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department.

Correct

- MD20050 $MC_AXCONF_GEOAX_ASSIGN_TAB

- MD24... $MC_TRAFO_AXES_IN_...

- MD24... $MC_TRAFO_GEOAX_ASSIGN_TAB_...

- MD22420 $MC_FGROUP_DEFAULT_AXES

- and/or MD20070 $MC_AXCONF_MACHAX_USED.

Program Con-

tinuation:

Switch control OFF - ON.

4004 [Channel %1: ] Machine data %2 axis %3 defined repeatedly as geometry

axis

Parameters: %1 = Channel number

%2 = String: MD identifier

%3 = Axis index

Definitions: An axis may only be defined once as a geometry axis.

Reaction: Mode group not ready.

Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Correct MD20050 $MC_AXCONF_GEOAX_ASSIGN_TAB.

Program Con-

tinuation:

Switch control OFF - ON.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl