Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 200)

Overview of alarms 06/2009

Cycle alarms

2-200

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61107 [Channel %1: ] Block %2: First drilling depth incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: First drilling depth is in the opposite direction to the total drilling depth. Alarm triggered by following

cycle: CYCLE83.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify drilling depth.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61108 [Channel %1: ] Block %2: Values for parameters _RAD1 and _DP1 not

permissible

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The parameters _RAD1 and _DP for defining the path for the depth infeed have been incorrectly spec-

ified. Alarm triggered by following cycles: POCKET3, POCKET4.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify parameter.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61109 [Channel %1: ] Block %2: Parameter _CDIR incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The value of the parameter for the cutting direction _CDIR has been incorrectly defined. Alarm trig-

gered by following cycles: POCKET3, POCKET4.

Remedy: Change parameter _CDIR.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61110 [Channel %1: ] Block %2: Finishing allowance at bottom > depth infeed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The finishing allowance at the base has been specified greater than the maximum depth infeed. Alarm

triggered by following cycles: POCKET3, POCKET4.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Either reduce finishing allowance or increase depth infeed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61111 [Channel %1: ] Block %2: Infeed width > Tool diameter

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The programmed infeed width is greater than the diameter of the active tool. Alarm triggered by fol-

lowing cycles: CYCLE71, POCKET3, POCKET4.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Infeed width must be reduced.

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 200

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl