Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 203)

Cycle alarms

06/2009 Overview of alarms

2-203

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61121 [Channel %1: ] Block %2: Number of teeth per cutting edge is missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No value was entered for the number of teeth per cutting edge. Alarm triggered by following cycles:

CYCLE70.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter the number of teeth/cutting edges for the active tool into the tool list.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61122 [Channel %1: ] Block %2: Safety distance incorrectly defined in plane

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The safety clearance is negative or zero. This is not allowed.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Define the safety clearance.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61123 [Channel %1: ] Block %2: CYCLE72 cannot be simulated

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61124 [Channel %1: ] Block %2: Infeed width is not programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE71.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: With active simulation without tool, a value for the infeed width _MIDA must always be programmed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61125 [Channel %1: ] Block %2: Technology selection in parameter _TECHNO

incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check parameter _TECHNO.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 203

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl