Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 253)

Cycle alarms

06/2009 Overview of alarms

2-253

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Check values in grinding wheel data

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61601 [Channel %1: ] Block %2: Finished part diameter too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The programmed radius of the machined part is too small. Alarm triggered by following cycles:

CYCLE94, CYCLE96.

Remedy: Check parameter SPD or DIATH.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61602 [Channel %1: ] Block %2: Tool width incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Plunge cutter is larger than the programmed groove width. Alarm triggered by following cycle:

CYCLE93.

Remedy: Check tool or change program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61603 [Channel %1: ] Block %2: Recess type incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Radii/chamfers at the groove base do not match the groove width. Face groove on a contour element

running parallel to the longitudinal axis is not possible. Alarm triggered by following cycle: CYCLE93.

Remedy: Check parameter VARI.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61604 [Channel %1: ] Block %2: Active tool violates programmed contour

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Contour violation in the relief cut elements due to the tool clearance angle of the tool used. Alarm trig-

gered by following cycle: CYCLE95.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use a different tool or check the contour subroutine.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61605 [Channel %1: ] Block %2: Contour incorrectly programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Illegal relief cut element detected. Alarm triggered by following cycles: CYCLE76, CYCLE77,

CYCLE95.

Remedy: Check contour program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61606 [Channel %1: ] Block %2: Error during contour preparation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An error has been found on conditioning the contour. This alarm is always related to one of NCK

alarms 10930...10934, 15800 or 15810. Alarm triggered by following cycle: CYCLE95.

Remedy: Check contour subroutine.

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 253

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl