Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 65)

NCK alarms

06/2009 Overview of alarms

2-65

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Definitions: The following types of interpolation are allowed in the contour program for stock removal: G00, G01,

G02, G03, CIP, CT

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: In the contour subroutine, program only path elements that consist of straight lines and arcs.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10931 [Channel %1: ] Block %2 incorrect stock removal contour

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The following errors occurred in the subroutine for the contour during stock removal:

- Full circle

- Overlapping contour elements

- Wrong start position

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The errors listed above must be corrected in the subroutine for the stock removal contour.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10932 [Channel %1: ] Block %2 preparation of contour has been restarted

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The first contour preparation/contour decoding run must be terminated with EXECUTE.

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Program the keyword EXECUTE to terminate the contour preparation in the part program before again

calling up contour segmentation (keyword CONTPRON).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10933 [Channel %1: ] Block %2 contour programm does not contain enough

contour blocks

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The contour program contains:

- Less than 3 contour blocks with CONTPRON

- No contour blocks with CONTDCON

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase the size of the program with the stock removal contour to include at least 3 NC blocks with

movements in both axes of the current machining plane.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10934 [Channel %1: ] Block %2 array for contour segmentation is set too small

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 65

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl