Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 196)

Overview of alarms 06/2009

Cycle alarms

2-196

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61014 [Channel %1: ] Block %2: Return plane exceeded

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm triggered by following cycles: CYCLE72.

Remedy: Check parameter RTP.

61015 [Channel %1: ] Block %2: Contour is not defined

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm triggered by following cycles: .

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61016 [Channel %1: ] Block %2: System frame for cycles missing

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: All measuring cycles can trigger this alarm.

Remedy: Set MD 28082: MM_SYSTEM_FRAME_MASK, Bit 5=1.

61017 [Channel %1: ] Block %2: function %4 not present in NCK

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm triggered by following cycles: .

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61018 [Channel %1: ] Block %2: function %4 not executable with NCK

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm triggered by following cycles: .

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61019 [Channel %1: ] Block %2: Parameter %4 incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm triggered by following cycles: CYCLE60, CYCLE83.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check the value of the parameter.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 196

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl