Siemens SINUMERIK 802D sl Betreibershandbuch PDF herunterladen (Seite 129)

NCK alarms

06/2009 Overview of alarms

2-129

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16751 [Channel %1: ] Block %2 spindle/axis %3 SPCOF not executable

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: For the programmed function, the spindle must be in the open-loop control mode. In the positioning

or axis mode, the position control must not be deselected.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Put the spindle into open-loop control mode in the preceding block. This can be done with M3, M4 or

M5 for the relevant spindle.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16755 [Channel %1: ] Block %2 no stop required

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No Stop is needed for the programmed function. A Stop is necessary after SPOSA or after M5 if the

next block is to be loaded only after a spindle stop.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Do not write instruction.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16760 [Channel %1: ] Block %2 axis %3 S value missing

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: No spindle speed has been given for rigid tapping (G331 or G332).

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program the spindle speed under address S in [rpm] (in spite of axis mode); the direction of rotation

is given by the sign of the spindle lead:

- Positive thread pitch: Rotational direction as M03.

- Negative thread pitch: Rotational direction as M04 N2.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16762 [Channel %1: ] Block %2 spindle %3 thread function is active

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Spindle number

Definitions: Incorrect programming: the spindle function can currently not be executed. This alarm occurs when

the spindle (master spindle) is linked with the axes by an interpolation function.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program. Deselect thread cutting or tapping.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 339 340

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Betreibershandbuch Seite 129

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl